L'ASA offre une bonne résistance aux huiles, graisses et détergents courants. Résistance aux solvants organiques (acétone, toluène) similaire à l'ABS : limitée. Tenue aux UV nettement supérieure grâce aux groupements acrylate.
ASA (Acrylonitrile Styrene Acrylate) + PA (Polyamide)
AS ABOVE SO BELOW
ASA (Acrylonitrile-Styrene-Acrylate) + PA (Polyamide)
Acrylonitrile Styrene Acrylate (ASA)
← All Materials
Injection Moulding
Transparent Food Contact Recycled Biobased flame-retardant UV resistant
✓ This material meets the criteria ~ Specialized grades may meet this criteria
Quality Scores
Mechanics
Thermal
Chemical
UV ageing
Injection moulding difficulty
Recycling
Performance profile
Mechanical properties
| Density | 1.07 to 1.17 g/cm³ ISO 1183 |
|---|---|
| Charpy notched impact | 4.0 to 100 kJ/m2 |
| Flexural modulus | 2300 MPa |
| Flexural resistance | 65 MPa |
| Tensile modulus | 1700 to 3230 MPa ISO 527-1 |
| Tensile resistance | 44.0 to 57.0 MPa ISO 527-1, -2, Yield |
| Tensile strain | 2.8 to 6.0 % ISO 527-1, -2, Yield |
Chemical resistance and characteristics
Chemical resistance
<
Recommended applications
- Car exterior parts
- Automotive Applications
- Outdoor applications
- Garden equipment
- Electrical/Electronic Applications
- Building and construction applications
- Marine Applications
- Profiles
- Sheet / plate
- Enclosures
Frequently asked questions
Injection moulding at 200–260 °C, mould temperature 40–80 °C. Pre-drying: 2–3 hours at 80 °C. Flow behaviour similar to ABS. Low shrinkage (0.4–0.7 %). Good suitability for glossy finishes.
ASA is recyclable (code 7). Its UV-stabilised properties are maintained better after recycling than ABS. Primarily industrial avenues.
Standard ASA is not certified for food contact. Use PP or PE for all food applications.
OUR MANUFACTURING LOCATIONS
OUR INDUSTRIAL SOLUTIONS
Western Europ
Asia
Eastern Europ
All rights reserved © | Hybster 2026