ASA (Acrylonitrile Styrene Acrylate) + PA (Polyamide)
AS ABOVE SO BELOW
ASA (Acrylonitrile-Styrene-Acrylate) + PA (Polyamide)
Acrylonitrile Styrene Acrylate (ASA)
← All Materials
Injection Moulding
Transparent Food Contact Recycled Biobased flame-retardant UV resistant
✓ This material meets the criteria ~ Specialized grades may meet this criteria
Quality Scores
Mechanics
Thermal
Chemical
UV ageing
Injection moulding difficulty
Recycling
Performance profile
Mechanical properties
| Density | 1.07 to 1.17 g/cm³ ISO 1183 |
|---|---|
| Charpy notched impact | 4.0 to 100 kJ/m2 |
| Flexural modulus | 2300 MPa |
| Flexural resistance | 65 MPa |
| Tensile modulus | 1700 to 3230 MPa ISO 527-1 |
| Tensile resistance | 44.0 to 57.0 MPa ISO 527-1, -2, Yield |
| Tensile strain | 2.8 to 6.0 % ISO 527-1, -2, Yield |
Chemical resistance and characteristics
Chemical resistance
<
Recommended applications
- Car exterior parts
- Automotive Applications
- Outdoor applications
- Garden equipment
- Electrical/Electronic Applications
- Building and construction applications
- Marine Applications
- Profiles
- Sheet / plate
- Enclosures
Frequently asked questions
Injection moulding at 200–260 °C, mould temperature 40–80 °C. Pre-drying: 2–3 hours at 80 °C. Flow behaviour similar to ABS. Low shrinkage (0.4–0.7 %). Good suitability for glossy finishes.
ASA is recyclable (code 7). Its UV-stabilised properties are maintained better after recycling than ABS. Primarily industrial avenues.
Standard ASA is not certified for food contact. Use PP or PE for all food applications.
